User manual

Publication ENET-UM001I-EN-P - January 2010 69
Configure a Supervisor on a Device-level Ring Network Chapter 5
2. Click the Network tab to enable Supervisor Mode.
Configuration takes affect immediately; yo
u do not need to click Apply
or OK.
3. Click the Advanced button
to configure supervisor-related parameters,
as shown in the screen shot below.
For the Supervisor Precedence parameter, you must click Set after
ente
ring a value.
4. Click Set.
Click here to enable
Supervisor Mode.
IMPORTANT
For Beacon Interval, Beacon Timeout and Ring Protocol VLAN
ID, we recommend that you only use the default values.