User manual

68 Publication ENET-UM001I-EN-P - January 2010
Chapter 5 Configure a Supervisor on a Device-level Ring Network
Enable Ring Supervisor in RSLogix 5000 Programming Software
To enable a ring supervisor, you must use an AOP in RSLogix 5000
programming software, version 17.01. After you have added your
1756-EN2TR module or 1783-ETAP, 1783-ETAP1F, or 1783-ETAP2F tap to
your RSLogix 5000 project, you must enable the ring supervisor.
To enable the 1756-EN2TR module or 1783-ETAP, 1783-ETAP1F, or
1
783-ET
AP2F tap as a ring supervisor, follow these steps.
1. With y
our project online with the controller
, double-click a
supervisor-capable device in the I/O configuration tree.
IMPORTANT
If you are using RSLogix 5000 programming software to
configure your ring supervisor and monitor diagnostics of your
DLR network, you must be online with your controller.
IMPORTANT
The steps to enable a ring supervisor are basically the same for
both the 1756-EN2TR module and the 1783-ETAP, 1783-ETAP1F,
or 1783-ETAP2F tap. This example shows how to do it for the
1756-EN2TR module.
Double-click the
module.