User manual

6 Publication ENET-UM001I-EN-P - January 2010
Table of Contents
Chapter 3
Configure Stratix Switches
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
Select a Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
Set Up the Hardware . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38
Switch Features. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38
Additional Resources . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
Chapter 4
Configure an EtherNet/IP Module
to Operate on the Network
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 41
Determine Network Parameters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 41
Set the IP Network Address . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43
Assign Network Parameters via the BOOTP/DHCP Utility . . . . . . . 45
Other Methods to Assign Network Parameters . . . . . . . . . . . . . . . . . . 47
Configure the Module with RSLinx Software . . . . . . . . . . . . . . . . 48
Configure Your Module with RSLogix 5000 Software . . . . . . . . . 50
Use DHCP Software to Set the IP Address. . . . . . . . . . . . . . . . . . 51
Duplicate IP Address Detection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 51
Detection of Duplicate IP Addresses . . . . . . . . . . . . . . . . . . . . . . . 53
IP Address Swapping . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 53
DNS Addressing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 54
Use EtherNet/IP Modules in a Logix5000
Controller Application . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55
Chapter 5
Configure a Supervisor on a
Device-level Ring Network
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 57
Rockwell Automation Products with Embedded
Switch Technology. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 58
Features Common to Products with Embedded
Switch Technology. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 59
Supervisor Node . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 61
Ring Node . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 63
Construct the Physical Network . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 63
Configure Supervisor Nodes on a DLR Network . . . . . . . . . . . . . . . . 64
Configure a Ring Supervisor in RSLogix 5000
Programming Software . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65
Enable Ring Supervisor in RSLogix 5000
Programming Software . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 68
Configure and Enable a Ring Supervisor in RSLinx Classic
Communication Software . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 71
Complete the Physical Connections of the Network. . . . . . . . . . . . . . 74
Verify Supervisor Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 75
Troubleshoot DLR Network Issues . . . . . . . . . . . . . . . . . . . . . . . . . . . 75