User manual

50 Publication ENET-UM001I-EN-P - January 2010
Chapter 4 Configure an EtherNet/IP Module to Operate on the Network
Configure Your Module with RSLogix 5000 Software
To use RSLogix 5000 programming software to configure the EtherNet/IP
module, perform this procedure.
1. Make sure the module is installed, started and connected to the
con
troller via a serial, or other network, connection.
2. In the Controller Organizer of RSLogix 5000 programming software,
righ
t-click the EtherNet/IP module and choose Properties.
The Module Properties dialog box appears. The example screen below
sh
ows the Module Properties dialog box for the 1756-ENBT module.
3. Click the Port Configuration tab.
4. In the IP Address field, type the IP address.
a.
In the other fields, type the other network
parameters, if needed.
5. Click Apply.
6. Click OK.
IMPORTANT
The fields that appear vary from one EtherNet/IP
module to another.