User manual

48 Publication ENET-UM001I-EN-P - January 2010
Chapter 4 Configure an EtherNet/IP Module to Operate on the Network
Configure the Module with RSLinx Software
To use RSLinx software to configure the EtherNet/IP module, perform this
procedure.
1. Make sure the module is installed and started.
2. In RSLinx software, from the Communications pull-down menu,
c
hoose RSWho.
The RSWho dialog box appears.
3. Navigate in RSWho to the Ethernet netw
ork.
4. Right-click the EtherNet/IP module and select Module Configuration.
T
he Module Configuration dialog box appears.