User manual

46 Publication ENET-UM001I-EN-P - January 2010
Chapter 4 Configure an EtherNet/IP Module to Operate on the Network
The hardware address is on a sticker on the side of the EtherNet/IP
module. The format of the hardware address resembles
00-0b-db-14-55-35.
The New Entry window appears with the module’s Ethernet Address
(MAC
).
6. Enter the IP address, host name, and a module description.
7. Click OK.
8. To permanently assign this configuration to the module, highlight the
module
and click the Disable BOOTP/DHCP button.
When power is recycled, the module uses the assigned configuration and
does
not issue a BOOTP request.
If you do not select the Disable BOOTP/DHCP bu
tton, on a power
cycle, the host controller clears the current IP configuration and will
again begin sending BOOTP requests.