User manual

Publication ENET-UM001I-EN-P - January 2010 203
Status Indicators Appendix A
If the PORT status indicator is flashing red, take the following actions.
1. Verify that cables are securely connected and not damaged; replace
ca
bles if necessary.
2. Cycle power to the drive (or adapter, if mounted in a DPI External
Comms kit).
If the PORT status indicato
r is solid red, take any of the following
actions.
• Verify that all DPI cables on the drive are securely connected and not
damage
d. Replace cables if necessary.
• Verify that the DPI drive supports Datalinks.
• Configure the adapter to use a Datalink that is not already being used by
a
not
her peripheral.
If the MOD status indicator is flashing r
ed, take the following actions.
1. Clear faults in the adapter.
2. Cycle power to the drive (or adapter if mounted in a DPI External
Comms Kit).
If cy
cling power does not correct the problem, the adapter parameter
sett
ings may have been corrupted.
3. Reset defaults and reconfigure the adapter.
4. If resetting defaults does not correct
the problem, flash the adapter with
the latest firmware release.
If the MOD status indicator is solid red, tak
e the following actions.
1. Cycle power to the drive (or adapter if mounted in a DPI External
Comms Kit).
2. Replace the adapter.
If the MOD status indicator is flashing green, tak
e the following
actions.
1. Place the scanner in R
UN mode.
IMPORTANT
Cycle power to the drive (or adapter if mounted in a DPI
External Comms Kit) after making any of the following
corrections.