User manual

202 Publication ENET-UM001I-EN-P - January 2010
Appendix A Status Indicators
If the PORT status indicator is off, take the following actions.
1. Securely connect the adapter to the drive using the Internal Interface
(ribb
on) cable.
2. Apply power to the drive (or adapter if mounted in a DPI External
Comm
s Kit).
MOD Off The adapter is not powered or is not properly connected to the drive. Securely
connect the adapter to the drive using the Internal Interface (ribbon) cable.
Apply power to the drive (or adapter if mounted in a DPI External Comms Kit).
Flashing Red The adapter has failed the firmware test or the adapter is being flash
upgraded. Follow the corrective action below.
Solid Red The adapter has failed the hardware test. Follow the corrective action below.
Flashing Green The adapter is operational, but is not transferring I/O data. Follow the
corrective action below.
Solid Green The adapter is operational and transferring I/O data. No action is required.
NET A Off One of the following:
• The adapter and/or network is not powered. In this case, securely connect
the adapter to the drive using the Internal Interface (ribbon) cable and to the
network using an Ethernet cable.
• The adapter is not properly connected to the network. In this case, correctly
connect the Ethernet cable to the Ethernet connector.
• The adapter needs an IP address. In this case, set a unique IP address using
a BOOTP server or by disabling BOOTP and using adapter parameters.
Additionally, make sure you have properly applied power to the drive (or
adapter, if mounted in a DPI External Comms kit) and the network.
Solid Red The adapter failed the duplicate IP address detection test. Configure the
adapter to use a unique IP address and cycle power.
Flashing Red An EtherNet/IP connection has timed out. Follow the corrective action below.
Flashing Red/Green The adapter is performing a self-test. No action is required.
Flashing Green The adapter is properly connected but is not communicating with any devices
on the network. Follow the corrective action below.
Solid Green The adapter is properly connected and communicating on the network. No
action is required.
NET B Off The adapter is not powered or is not transmitting on the network. If the adapter
is not idle, follow the corrective action below.
Flashing Green The adapter is transmitting on the network. No action is required.
Module Status Indicator
Indicator Status Description