User manual

190 Publication ENET-UM001I-EN-P - January 2010
Appendix A Status Indicators
NS
Off The daughtercard does not have an IP address and is operating in BOOTP
mode. Verify that the BOOTP server is running.
Flashing green The daughtercard has an IP address, but no CIP connections are established.
Follow
the corrective action below.
Green The daughtercard has an IP address and CIP connections (Class 1 or Class 3)
are established. No action is required.
Red A duplicate IP address has been
detected. Make sure that the IP address
assi
gned to this module is not the same as that for any other device already on
the network.
LNK
Off The daughtercard is not connected to a powered Ethernet module. The
daughtercard cannot communicate on an Ethernet network.
Follow the corrective action below.
Flashing green The daughtercard is performing a self test while it is being started. No action
is required.
The daughtercard is communicating on an Ethernet network. No action is
required.
Green The daughtercard is connected to a powered Ethernet module. The
daughtercard can communicate on an Ethernet network. No
actio
n is required.
U%
Off The I/O packet rate to/from this daughtercard is less than 80% of the available
packet rate, and less than 80% of the 32 available I/O connections are
currently in use. No action is required.
Flashing green The I/O packet rate to/from this daughtercard is at least 80% of the available
pack
et rate (4000 pack
ets/s). That is, the I/O packet rate is at least 3200
packets/s. No action is required.
At least 80% of the 32 available connections are currently in use. That is, from
26 to 31 I/O connec
tions
are in use. No action is required.
Green All 32 of the daughtercard’s I/O connections are currently in use. No action is
required.
Flas
hing red/green The daughtercard is performing a self test while it is being started. No action
is required.
Status Indicator
Indi
cator Status Description