User manual

Publication 1734-UM011A-EN-P - February 2004
Configure the RSLinx Ethernet Communication Driver B-3
You will be prompted to name the driver.
5. Select the default driver name (e.g., AB_ETH-1) or type in your own
name and click on OK.
The Configure driver window will appear with the Station Mapping
page open.
6. Click on Add New and enter the IP address or Host Name of your
Ethernet device (e.g., 10.88.70.4, “Pump1”, etc.).
7. Repeat step 6 for each additional Ethernet device you need to access.
8. When you are done entering the IP addresses, click on Apply. Then click
on OK to close the Configure driver window.