User manual

1 Publication 1734-UM011A-EN-P - February 2004

Chapter

Configure the 1734-AENT for Direct

Connection in RSLogix 5000

About the Example

Application

In this example, a ControlLogix processor communicates with POINT I/O

via the 1734-AENT adapter using a direct connection. The adapter will make a

direct connection to each of the modules referenced by the data. Note that the

modules presented in this chapter are configured using RSLogix 5000, version

11.

What you will do See page

Set Up the Hardware 4-2

Create the Example Application 4-3

Configure the I/O 4-4

Add the Local EtherNet/IP Bridge to the I/O Configuration 4-4

Add the POINT I/O Adapter to the I/O Configuration 4-6

Add the POINT I/O Modules to the I/O Configuration 4-8

Add the Relay Output Module 4-8

Add the Digital Output Module 4-11

Edit the Controller Tags 4-13

Create the Ladder Program 4-14

Download the Program to the Controller 4-15

Verify the Module Chassis Size 4-16

Configure the 1734-AENT with Fixed IP Address 4-18

An Overloaded 1734-AENT 4-19

ATTENTION

You must use Series C POINT I/O modules with the

1734-AENT adapter. Series A or B POINT I/O

modules will not work with this adapter.