User manual

Publication 1734-UM011A-EN-P - February 2004
D-6 1734-AENT Quick Start
It is set to 1, which is one of the default values. If you look to Appendix
C of this user manual, you will see that there are two settings that this
module will support:
• 1 = 0 to 10VDC
• 3 = -10 to +10VDC
Please note the following:
• The controller only sends the configuration data when connection is
being established.
• Should you need to modify any of the tag values once you change the
tag, you will need to access the updated information and download it
into the module. There are three ways to download the updated
configuration information into the module.
– Ideally, you would enter the correct code number in the Range Type
field at the same time that you add the I/O to the I/O Configuration
tree. You would then download later
.