User Guide

Publication DNET-UM004A-EN-P - March 2004
Connect Each Device to the Network 5-3
Set an Address with
Software
To use RSNetWorx software to set the address of a device:
2. Click Browse.
1. Choose Start ⇒ Programs ⇒ Rockwell Software ⇒ RSNetWorx ⇒ DeviceNet Node Commissioning Tool.
3. Check this box.
4. Browse to the DeviceNet network.
5. Type the current address for the
device. Out of the box, a device
uses address 63.
6. Click OK.
7. Type the new address for the device.
8. Apply the change.
9. Look for confirmation here.