User Guide

Publication DNET-UM004A-EN-P - March 2004
4-8 Automatically Configure a DeviceNet Network
Turn On AutoScan
IMPORTANT
In the following steps, you clear any existing configuration from the
scanner and reconfigure its to communicate with the devices on your
network.
• In the controller, this may change the tag addresses of the devices.
• If you have already programmed your logic, make sure that it still
addresses the correct data.
3. Select (check) this check box.
4. Choose OK.
A blue dot indicates a device that the scanner now
controls.
1. Double-click the scanner.
2. Click the Scan List tab.