User manual

Rockwell Automation Publication 1756-UM001O-EN-P - October 2014 47

Start Using the Controller Chapter 3

Figure 3 - USB Connection

Configure the USB Driver

To configure RSLinx software to use a USB port, you must first configure a USB

driver.

To configure a USB driver, perform this procedure.

1. Connect your controller and workstation by using a USB cable.

The Found New Hardware Wizard dialog box appears.

2. Click any of the Windows Update connection options and click Next.

TIP

If the software for the USB driver is not found and the installation is

canceled, verify that you have installed RSLinx Classic software,

version 2.57 or later.

Log

ix 55

RUN

FORCE

32007-M