User manual

190 Rockwell Automation Publication 1756-UM001O-EN-P - October 2014
Appendix A Troubleshoot the Module
61 Task Watchdog Expired
740 Save Failure
7 41 Bad Restore Type
7 42 Bad Restore Revision
7 43 Bad Restore Checksum
7 44 Failed to Restore Processor Memory
8 1 Keyswitch Change Ignored
11 1 Positive Overtravel Limit Exceeded
11 2 Negative Overtravel Limit Exceeded
11 3 Position Error Tolerance Exceeded
11 4 Encoder Channel Connection Fault
11 5 Encoder Noise Event Detected
11 6 Sercos Drive Fault
11 7 Synchronous Connection Fault
11 8 Servo Module Fault
11 9 Asynchronous Connection Fault
11 10 Motor Fault
11 11 Motor Thermal Fault
11 12 Drive Thermal Fault
11 13 Sercos Communications Fault
11 14 Inactive Drive Enable Input Detected
11 15 Drive Phase Loss Detected
11 16 Drive Guard Fault
11 32 Motion Task Overlap Fault
11 33 CST Reference Loss Detected
12 32 Disqualified Secondary Controller Cycle Power
12 33 Unpartnered Controller Identified in New Primary Chassis
12 34 Keyswitch Positions of Primary and Secondary Controllers Mismatched
14 1 Safety Task Watchdog Expired
14 2 Error In Routine of Safety Task
14 3 Safety Partner Missing
14 4 Safety Partner Unavailable
14 5 Safety Partner Hardware Incompatible
14 6 Safety Partner Firmware Incompatible
14 7 Safety Task Inoperable
14 8 Coordinated System Time (CST) Not Found
14 9 Safety Partner Nonrecoverable Controller Fault
18 1 CIP Motion Initialization Fault
18 2 CIP Motion Initialization Fault Mfg
Table 50 - Major Fault Status Messages (Continued)
Type Code Message