Specifications

Allen-Bradley ControlLogix Ethernet Driver Help
Possible Cause:
1. The packets are misaligned (due to connection/disconnection between the PC and device).
2. There is bad cabling connecting the device that is causing noise.
Solution:
1. Place the device on a less noisy network.
2. Increase the request timeout and/or attempts.
3. Restart the server and try again.
Note:
A project upload is required for the Logical Addressing Modes.
Invalid or corrupt controller project detected while synchronizing.
Synchronization will be retried shortly.
Error Type:
Warning
Possible Cause:
An invalid or corrupt controller project was detected during synchronization.
Solution:
No action is required. The driver will re-attempt synchronization after a period of 30 seconds.
Note:
Project synchronization is required for the Logical Addressing Modes.
Low memory resources.
Error Type:
Warning
Possible Cause:
Memory required for controller project upload could not be allocated.
Solution:
Close any unused applications and/or increase the amount of virtual memory. Then, restart the server and try
again.
Note:
A project upload is required for the Logical Addressing Modes.
Project download detected while synchronizing. Synchronization will be retried
shortly.
Error Type:
Warning
Possible Cause:
A project download was attempted while the device was synchronizing with the controller project.
Solution:
No action is required. The driver will re-attempt synchronization after a period of 30 seconds.
Note:
Project synchronization is required for the Logical Addressing Modes.
www. kepware.com
111