User manual

A–B
F
Appendix
F–1
Scanner Commands
Each label in this manual is preceded by two
characters which represent the serial command for a
scanner parameter. The following tables list the
command mnemonic for each scanner parameter and
the page location of the corresponding label.
General Scanner Setup Parameters
Mnemonic
Function Page #
ZA Set Scanner to Factory Defaults 4-10
ZB Display Scanner Configuration 5-1
ZC Transmit Program Version Number 5-2
@C Transmit Program ID 5-2
@A Enable Full Continuous Power 5-3
@B Enable Standby Power 5-3
AA Beeper Off 5-4
AB Beeper On; Volume Low 5-4
AC Beeper On; Volume Medium 5-4
AD Beeper On; Volume Loud 5-4
BC Capture Count=1 5-5
BD Capture Count=2 5-5
NP Disable Spotter Beam 5-6
NQ Enable Spotter Beam 5-6
NO Enable Autosense Mode 5-7
NN Disable Autosense Mode 5-7
HA Disable External Trigger 5-8
HE External Trigger (+) 5-8
HF External Trigger (–) 5-8