User manual
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Connecting the Scanner
- Overview
- Scanner Cable Connection
- Scanner Cable to Synapse Cable Connection
- Scanner Emulation Synapse Cable Connections
- RS-232 Synapse Cable Connections
- Keyboard Wedge Synapse Cable Connections
- Scanner to Enhanced Decoder Scanner Port Connection
- Scanner to Enhanced Decoder Aux Port Connection
- Scanner to Flexible Interface (RB) Module Connection
- Scanner to PLC Connection
- Scanner to SLC Connection
- 3 - Operating the Scanner
- 4 - Configuring the Scanner
- 5 - Communication Setup (Synapse Cable)
- 6 - Troubleshooting and Maintenance
- A - Specifications
- B - Scanner Pinout Collections
- C - ASCII Chart
- D - AIM Code Identifiers
- E - Advanced Data Formatting
- F - European Union Directives
- Glossary
- Index
- Back Cover
Troubleshooting and Maintenace 6–3
Publication 2755-6.4
Problem Probable Cause(s) Corrective Action
Scan Beam Present,
Symbols Not Read
1. Scanner not set to decode
symbol type scanned.
2. Scanner not held at slight
angle to symbol.
3. Scan beam not crossing
entire symbol.
4. Poor quality bar code
symbols.
5. Loose cable connections.
6. Incorrect interface cable.
1. Verify the scanner decoder
settings.
2. Hold scanner at an angle
to the symbol.
3. Make sure scan beam
crosses every bar and
space on the symbol.
4. Use the symbols provided
on the inside back cover
for testing.
5. Check for loose cable
connections.
6. Check that you are using
the proper cable.
Data is decoded but not
transmitted to host.
1. Scanner is not configured
for the proper cable.
2. Loose connections
3. Scanner communication
settings do not match host
requirements.
1. Make sure the scanner is
configured for the correct
cable (standard RS-232 or
smart cable).
2. Check all cable
connections.
3. Verify cable
communication settings
such as baud rate.