User manual
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Connecting the Scanner
- Overview
- Scanner Cable Connection
- Scanner Cable to Synapse Cable Connection
- Scanner Emulation Synapse Cable Connections
- RS-232 Synapse Cable Connections
- Keyboard Wedge Synapse Cable Connections
- Scanner to Enhanced Decoder Scanner Port Connection
- Scanner to Enhanced Decoder Aux Port Connection
- Scanner to Flexible Interface (RB) Module Connection
- Scanner to PLC Connection
- Scanner to SLC Connection
- 3 - Operating the Scanner
- 4 - Configuring the Scanner
- 5 - Communication Setup (Synapse Cable)
- 6 - Troubleshooting and Maintenance
- A - Specifications
- B - Scanner Pinout Collections
- C - ASCII Chart
- D - AIM Code Identifiers
- E - Advanced Data Formatting
- F - European Union Directives
- Glossary
- Index
- Back Cover
Communication Setup (Synapse Cable) 5–23
Publication 2755-6.4
Advanced Features
The advanced feature options allow you to store communication
parameters for 2 separate applications. If you have already
configured the scanner, all of the communication settings are stored
as Parameter 1 settings (default setting). Using the advanced feature
options, you can also create Parameter 2 settings. When using the
scanner, scan the correct parameter setting bar code for each
application.
To select and/or set Parameter Set 1 configuration:
Configure the scanner communications as described in this chapter.
Since Parameter Set 1 is the default you do not have to scan the
Parameter Set 1 bar code.
To change the Parameter Set 1 configuration after storing settings in
Parameter Set 2, scan the Parameter Set 1 code and then change the
communication parameters as necessary.
To set Parameter Set 2 configuration:
1. Scan the Parameter Set 2 bar code.
2. Configure the scanner communication parameters as described in
this chapter.
To select and/or set defaults for a parameter set, scan the appropriate
default bar code. The selections are:
• Set Defaults Current Parameter Set
• Set Defaults Both Parameter Sets