User manual
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Connecting the Scanner
- Overview
- Scanner Cable Connection
- Scanner Cable to Synapse Cable Connection
- Scanner Emulation Synapse Cable Connections
- RS-232 Synapse Cable Connections
- Keyboard Wedge Synapse Cable Connections
- Scanner to Enhanced Decoder Scanner Port Connection
- Scanner to Enhanced Decoder Aux Port Connection
- Scanner to Flexible Interface (RB) Module Connection
- Scanner to PLC Connection
- Scanner to SLC Connection
- 3 - Operating the Scanner
- 4 - Configuring the Scanner
- 5 - Communication Setup (Synapse Cable)
- 6 - Troubleshooting and Maintenance
- A - Specifications
- B - Scanner Pinout Collections
- C - ASCII Chart
- D - AIM Code Identifiers
- E - Advanced Data Formatting
- F - European Union Directives
- Glossary
- Index
- Back Cover
Communication Setup (Synapse Cable) 5–21
Publication 2755-6.4
Emulation Timeout
Determines how long:
• the Synapse cable waits for the laser on signal from the scanner
after the trigger is pulled.
• the scanner waits for a decode LED (check if Decode LED is
enabled).
The options:
• 3 second timeout (default)
• 4 second timeout
• 5 second timeout
• 10 second timeout
• 30 second timeout
Polarity
Sets the polarity of the wand emulation signal. The selections are:
• Margin Low / Bar High (default)
• Margin High / Bar Low
Unknown Characters
Unknown characters are characters not recognized by the scanner.
When Send Bar Codes with Unknown Characters is enabled, all
decoded bar code data is transmitted except for the unknown
characters. If this option is disabled, bar codes containing one or
more unknown characters are not transmitted.