User manual
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Connecting the Scanner
- Overview
- Scanner Cable Connection
- Scanner Cable to Synapse Cable Connection
- Scanner Emulation Synapse Cable Connections
- RS-232 Synapse Cable Connections
- Keyboard Wedge Synapse Cable Connections
- Scanner to Enhanced Decoder Scanner Port Connection
- Scanner to Enhanced Decoder Aux Port Connection
- Scanner to Flexible Interface (RB) Module Connection
- Scanner to PLC Connection
- Scanner to SLC Connection
- 3 - Operating the Scanner
- 4 - Configuring the Scanner
- 5 - Communication Setup (Synapse Cable)
- 6 - Troubleshooting and Maintenance
- A - Specifications
- B - Scanner Pinout Collections
- C - ASCII Chart
- D - AIM Code Identifiers
- E - Advanced Data Formatting
- F - European Union Directives
- Glossary
- Index
- Back Cover
Communication Setup (Synapse Cable) 5–19
Publication 2755-6.4
Setting Scanner Emulation Synapse Cable Options
This section defines the communication options available when the
scanner is connected to this Scanner Emulation Synapse cable:
• Catalog No. 2755-HFC-SA1-01
Default Settings
Scan the Set Scanner Emulation Cable Defaults bar code to set the
Synapse cable to default settings. Refer to the table below for the
default settings.
Parameter Default Setting
Refer to
Description
on Page:
Programming
Guide➀
Page Reference
Emulation Standard 5–20 6-2
Leading Margin 80 Millisecond 5–20 6-3
Decode LED Enabled 5–20 6-3
Emulation Timeout 3 Seconds 5–21 6-4
Polarity Margin Low / Bar High 5–21 6-5
Unknown Characters
Send Bar Codes with
Unknown Characters
5–21 6-5
Convert All to Code 39 Disabled 5–22 6-6
Code 39 to Code 39
Full ASCII
Disabled 5–22 6-6
Parameter Set Parameter Set 1 5–23 6-7
➀ Programming Guide for 2-D Bar Code Scanners (Publication 2755-6.7)