User manual
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Connecting the Scanner
- Overview
- Scanner Cable Connection
- Scanner Cable to Synapse Cable Connection
- Scanner Emulation Synapse Cable Connections
- RS-232 Synapse Cable Connections
- Keyboard Wedge Synapse Cable Connections
- Scanner to Enhanced Decoder Scanner Port Connection
- Scanner to Enhanced Decoder Aux Port Connection
- Scanner to Flexible Interface (RB) Module Connection
- Scanner to PLC Connection
- Scanner to SLC Connection
- 3 - Operating the Scanner
- 4 - Configuring the Scanner
- 5 - Communication Setup (Synapse Cable)
- 6 - Troubleshooting and Maintenance
- A - Specifications
- B - Scanner Pinout Collections
- C - ASCII Chart
- D - AIM Code Identifiers
- E - Advanced Data Formatting
- F - European Union Directives
- Glossary
- Index
- Back Cover
4–12 Configuring the Scanner
Publication 2755-6.4
Decode Options
Beep After Good Decode
When enabled, the beeper sounds during scanning. We recommend
that you operate the unit with the beeper enabled. The default is
enabled.
The beeper always operates during parameter menu scanning and
indicates error conditions. See page 3–8 for beeper indications.
Beeper Tone
Sets the decode beep frequency or tone to low, medium or high. The
default is high.
Decode Buffering
When enabled, this option allows the scanner to store decoded data
until the host device is ready to receive them. If the scanner reaches
its capacity for storing decoded symbols before the host is ready,
subsequent triggers have no effect until the buffer is available. The
default is disabled.
Pause Duration
This parameter inserts a pause after a bar code is scanned to allow
time for the data to be decoded and transferred to the host. You can
set a pause duration in .1 (1/10) second intervals from 0.1 to 9.9
seconds. Pauses are set by scanning a two digit number. The default
is 0.0 seconds.
For example, to set a .5 (1/2) second delay, scan the following labels:
– Pause Duration
– 0 (under Pause Duration)
– 5 (Under Pause Duration)