User manual
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Connecting the Scanner
- Overview
- Scanner Cable Connection
- Scanner Cable to Synapse Cable Connection
- Scanner Emulation Synapse Cable Connections
- RS-232 Synapse Cable Connections
- Keyboard Wedge Synapse Cable Connections
- Scanner to Enhanced Decoder Scanner Port Connection
- Scanner to Enhanced Decoder Aux Port Connection
- Scanner to Flexible Interface (RB) Module Connection
- Scanner to PLC Connection
- Scanner to SLC Connection
- 3 - Operating the Scanner
- 4 - Configuring the Scanner
- 5 - Communication Setup (Synapse Cable)
- 6 - Troubleshooting and Maintenance
- A - Specifications
- B - Scanner Pinout Collections
- C - ASCII Chart
- D - AIM Code Identifiers
- E - Advanced Data Formatting
- F - European Union Directives
- Glossary
- Index
- Back Cover
Configuring the Scanner 4–3
Publication 2755-6.4
Configuration Parameters
Programming
Guide Reference
Default Setting
Code Lengths
Code 39 – Any Length None 1-10
Code 39 – Length Within Range Range (1-55) 1-10
Code 39 – 1 Discrete Length None 1-10
Code 39 – 2 Discrete Lengths None 1-10
Codabar – Any Length Range (2-55) 1-11
Codabar – Length Within Range Range (2-55) 1-11
Codabar – 1 Discrete Length None 1-11
Codabar – 2 Discrete Lengths None 1-11
Interleaved 2 of 5 – Any Length Range (2-54) 1-12
Interleaved 2 of 5 – Length Within Range None 1-12
Interleaved 2 of 5 – 1 Discrete Length 14 1-12
Interleaved 2 of 5 – 2 Discrete Lengths None 1-12
Data Format Options
Prefix/Suffix Enter 1-14
Data Transmission Format <Data> As Is 1-16
Transmit No Read Message Disabled 1-17
Transmit LRC Checksum Disabled 1-17
Transmit Code ID Character Disabled 1-18
Decode Options
Beep After Good Decode Enabled 1-19
Beeper Tone High 1-19
Decode Buffering Disabled 1-19
Pause Duration 0.0 seconds 1-20
Decode Attempt Duration 5 seconds 1-20
Scanning Options
Smart Raster Mode Enabled 1-22
Hand-Held Options Slab Raster 1-22