User manual
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Connecting the Scanner
- Overview
- Scanner Cable Connection
- Scanner Cable to Synapse Cable Connection
- Scanner Emulation Synapse Cable Connections
- RS-232 Synapse Cable Connections
- Keyboard Wedge Synapse Cable Connections
- Scanner to Enhanced Decoder Scanner Port Connection
- Scanner to Enhanced Decoder Aux Port Connection
- Scanner to Flexible Interface (RB) Module Connection
- Scanner to PLC Connection
- Scanner to SLC Connection
- 3 - Operating the Scanner
- 4 - Configuring the Scanner
- 5 - Communication Setup (Synapse Cable)
- 6 - Troubleshooting and Maintenance
- A - Specifications
- B - Scanner Pinout Collections
- C - ASCII Chart
- D - AIM Code Identifiers
- E - Advanced Data Formatting
- F - European Union Directives
- Glossary
- Index
- Back Cover
Chapter 4
Publication 2755-6.4
Configuring the Scanner
This chapter describes the scanner configuration options.
Important Notes on Configuring Scanner
• Bar codes for configuring the scanner and Synapse cable are
located in the Programming Guide for 2-D Bar Code Scanners
(Publication 2755-6.7).
• Configure the scanner.
• Configure the Synapse cable. Separate configuration codes are
scanned to configure the cable.
Chapter 5 describes the communication setup (cable
configuration) codes for the RS-232, keyboard wedge cable,
scanner emulation.
Configuration Bar Codes for Scanner
All configuration bar codes are found in the Programming Guide for
2-D Bar Code Scanners (Publication 2755-6.7). The scanner is
always enabled to read Code 128 configuration bar codes since all
configuration codes use this symbology.