User manual
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Connecting the Scanner
- Overview
- Scanner Cable Connection
- Scanner Cable to Synapse Cable Connection
- Scanner Emulation Synapse Cable Connections
- RS-232 Synapse Cable Connections
- Keyboard Wedge Synapse Cable Connections
- Scanner to Enhanced Decoder Scanner Port Connection
- Scanner to Enhanced Decoder Aux Port Connection
- Scanner to Flexible Interface (RB) Module Connection
- Scanner to PLC Connection
- Scanner to SLC Connection
- 3 - Operating the Scanner
- 4 - Configuring the Scanner
- 5 - Communication Setup (Synapse Cable)
- 6 - Troubleshooting and Maintenance
- A - Specifications
- B - Scanner Pinout Collections
- C - ASCII Chart
- D - AIM Code Identifiers
- E - Advanced Data Formatting
- F - European Union Directives
- Glossary
- Index
- Back Cover
Connecting the Scanner 2–9
Publication 2755-6.4
To Host
Keyboard Connector
Power Supply
(May not be required,
see previous page.)
Scanner Cable
Wedge Synapse Cable
(2755-HFC-SP1-01 shown)
Scanner
To Keyboard
Note: Connect the
power supply last.
To connect the scanner cable to the keyboard wedge cable, push the
cable into the connector until you hear the connector snap in place.
To remove the scanner cable, press down on the small raised bump
on the connector end and remove cable.
!
ATTENTION: Do not install the wedge cable or
disconnect/connect the keyboard with power applied to
either the wedge cable or host device. Failure to
follow this caution may result in damage to the
scanner, wedge interface cable, or host device.
The Wedge Synapse cable connects between the keyboard and the
host device. Unplug the keyboard and connect one end of the wedge
cable to the host keyboard input. Connect the other end of the wedge
interface cable to the keyboard.