User manual
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Connecting the Scanner
- Overview
- Scanner Cable Connection
- Scanner Cable to Synapse Cable Connection
- Scanner Emulation Synapse Cable Connections
- RS-232 Synapse Cable Connections
- Keyboard Wedge Synapse Cable Connections
- Scanner to Enhanced Decoder Scanner Port Connection
- Scanner to Enhanced Decoder Aux Port Connection
- Scanner to Flexible Interface (RB) Module Connection
- Scanner to PLC Connection
- Scanner to SLC Connection
- 3 - Operating the Scanner
- 4 - Configuring the Scanner
- 5 - Communication Setup (Synapse Cable)
- 6 - Troubleshooting and Maintenance
- A - Specifications
- B - Scanner Pinout Collections
- C - ASCII Chart
- D - AIM Code Identifiers
- E - Advanced Data Formatting
- F - European Union Directives
- Glossary
- Index
- Back Cover
2–6 Connecting the Scanner
Publication 2755-6.4
RS-232 Synapse Cable Connections
Use the RS-232 Synapse cable to connect the scanner to any host
RS-232C input port. Two types of RS-232 Synapse cables are
available:
Catalog No. 2755-HFC-SR2-01
Catalog No. 2755-HFC-SR3-01
RS-232 Synapse
Cable
Output Connector Output Signal
2755-HFC-SR2-01 Male 25-pin DB RS-232C, Txd on Pin #3
2755-HFC-SR3-01 Female 9-pin DB RS-232C, Txd on Pin #2
!
ATTENTION: Do not install the RS-232 Synapse
cable with power applied to either the Synapse cable or
host device. Failure to follow this caution may result
in damage to the scanner, Synapse cable, or host
device.