User manual

Publication 1797-6.5.1 - April 1999
3-6 How to Install Your FLEX Ex Analog Modules
5. Rotate the terminal base onto the DIN rail with the top of the rail hooked
under the lip on the rear of the terminal base. Use caution to make sure
that the female flexbus connector does not strike any of the pins in
the mating male connector.
6. For specific wiring information, refer to the installation instructions for
the module you are installing in this terminal base unit. Terminal
assignments are also given later in this chapter, see page 3-11.
7. Repeat the above steps to install the next terminal base.
8. Be sure the flexbus connector cover on the last terminal base is in place.
Press down on the terminal base unit to lock the terminal base on the DIN rail. If
the terminal base does not lock into place, use a screwdriver or similar device to
open the locking tab, press down on the terminal base until flush with the DIN
rail and release the locking tab to lock the base in place.
41108
41109
Gently push the flexbus connector into the side of the adapter (or proceeding
terminal base) to complete the backplane connection.