User manual

Publication 1797-6.5.1 - April 1999
How to Install Your FLEX Ex Analog Modules 3-5
4. Position the terminal base over the 35 x 7.5mm DIN rail A
(A-B pt. no. 199-DR1).

ATTENTION: Do not force the terminal base
into the adjacent modules. Forcing the units
together can bend or break the hook and allow the
units to separate and break communication over
the backplane.
A
A
41106
Position terminal base at a slight angle and
hooked over the top of the DIN rail A.
41107
Slide the terminal base over tight against the adapter (or proceeding terminal
base). Make sure the hook on the terminal base slides under the edge of the
adapter (or proceeding terminal base) and the flexbus connector is fully
retracted.