User manual

1 Publication 1794-UM063A-EN-P - March 2006
Chapter 3
Install Your FLEX I/O Analog Modules
What This Chapter Contains
Read this chapter to install the input and output analog modules.
Before You Install Your
Analog Module
Before installing your FLEX I/O analog module:
For Information On See Page
Before You Install Your Analog Module 3-1
Removal and Insertion Under Power 3-2
Install the Module 3-2
Connect Wiring to the FLEX I/O HART
Analog Modules
3-8
Ground the Module 3-12
Chapter Summary 3-13
Table 3.1 Steps to Complete Before Installation
You Need To As Described Under
Verify that the module will be installed in a
suitable enclosure
Removal and Insertion Under Power, page
Page 3-2
Position the keyswitch on the
terminal base
Install the Module, page 3-7
ATTENTIONATTENTION
These modules do not receive primary operational power from
the backplane. +V and -V dc power must be applied to your
module before installation. If power is not applied, the module
position will appear to the adapter as an empty slot in your
chassis.