Specifications

113 Publication 1794-SG002D-EN-P - May 2012
Section 3.1
Mount the FLEX System
Step 6 – Select:
•panel mount or DIN rail mount
•appropriate number of panels or DIN rails based on the number of modules
and the physical requirements
•one end cap per controller system
You can horizontally or vertically mount the FLEX I/O or FLEX Ex I/O system
on a standard 35 mm DIN rail. The adapter and terminal base unit easily snap on
the DIN rail by hand. Use a flat-blade screwdriver to remove components from
the DIN rail.
Screw holes allow you to horizontally or vertically panel-mount your system in an
enclosure. Maintain at least 25 mm (1 in.) of air space around your FLEX system.
Connection point
Hook
Locking
lever
Side view
DIN rail
Screw holes for
panel-mounting
Components are
slotted to DIN rail
allow mounting.
Locking tab connector holds
terminal base onto DIN rail.
Remote I/O connector
Allen Bradley part. no. 94202903
DIN rail
Allen Bradley part no. 199-DR1
DIN 46277-3
EN 50022 (35 x 7.5 mm)