Technical data

A-B SuperBridge Technical Reference
25
Controller Bit Meaning
7 HPAD Not Set-Up
8 Test OverFlow
11.00.HP 1 Scale Overload
2 Scale Underload
3 A/D Underrange
4 A/D Overrange
5 Bad Tare
7 HPAD Not Set
8 Bad Low Display
9 Comm Lost
20.00.HP 1 A/D Overrange
2 Auto-Tare Reject
3 Master Comm Lost
4 A/D Underrange
5 Display Failure
6 Display Failure
7 HPAD Not Set-Up
8 Test OverFlow
30.00.HP 1 Scale Overload
2 Scale Underload
3 A/D Underrange
4 A/D Overrange
5 Slow Fill
6 Hopper Empty
7 HPAD Not Set
8 Bad Low Display
9 Comm Lost
11 Overfill
14 No HPAD Data
35.00.HP 1 Scale Overload
2 Scale Underload
3 A/D Underrange
4 A/D Overrange
5 Stable Timeout
Controller Bit Meaning
6 Batch Timeout
7 HPAD Not Set
8 Bad Low Display
9 Comm Lost
10 Slow Fill
11 Fill When Batch
14 No HPAD Data
24.96.EX 1 Belt Load Over
Limit
2 Belt Load Under
Limit
3 PCAD Near Zero
4 PCAD Near Full
5 Zero Tracking off
Limits
6 PCAD discrepancy,
load cells do not
agree
7 PCAD not setup
8 Tachos do not
comply
9 Comm Lost
10 Remote Setpoint
Out Of Range
11 No Speed Detected
12 Analog input out of
range.
13 MC³ Display Not
Responding
14 No Data from
PCAD
DIGITAL I/O
The Digital I/O bits are mapped out according to the following table. Detailed information is
available in the operations manual for the controllers. MC³ controllers are capable of mapping
logical inputs and outputs to physical I/O points. The actual mapping must be examined using the
‘Digital Inputs’ and ‘Digital Outputs’ mapping screens on the controller.
Controller I/O Bit Meaning
20.00.K O 0 High Alarm
Controller I/O Bit Meaning
O 1 Low Alarm