Specifications

8
www.kepware.com
Allen-Bradley DH+/DH-485 Device Driver Help
2. Select the Interface Card tab from the Channel Properties window.
3. In the Interface Card tab, configure the properties.

Select the Board Type: Select "KTX(D)" as the "Board Type" from the drop down menu next to the "Board
Type" label. Note: In our board type selection, we will be choosing KTX (D) for both the KTX and KTX-D cards.

Select the Network type: Select the type of network you are using. This driver currently supports DH+ and
DH-485 Network.

Enter the station address: This is a unique node ID (0-77 octal for DH+ and 0-31 decimal for DH-485) of your
device. You must make sure that this ID doesn't conflict with any other node ID on the network.

Select the Baud Rate: The available baud rates for the DH+ network are 57.6K, 115K and 230K. The Baud
rates 115K and 230K under the DH+ network may not be supported by the card you are using or the device you
are talking to. Check the card and device vendor specifications. The available baud rates for the DH-485 network
are 300, 600, 1.2K, 2.4K, 4.8K, 9.6K, 19.2K. Select the one that matches your device configuration.

Select the Memory Address: You must select the exact memory address that you set up on your card while
performing the hardware configuration.

Select the Interrupt: If you are using interrupts, you must select a unique interrupt level from the drop-down
menu next to the Interrupt label. Make sure it matches what you have selected while performing hardware