Specifications

www.kepware.com

Allen-Bradley DH+/DH-485 Device Driver Help

1. In the server application, right-click on the channel. Select Properties.

2. Select Interface Card tab from the Channel Properties window.

3. Configure the properties.



Select the Board Type: Select "KT" as the "Board Type" from the drop down menu next to the "Board Type"

label.



Select the Network Type: Select the type of network you are using. This driver currently supports DH+

Network only.



Select the Station Address: This is a unique node ID (0-77 octal) of your device. You must make sure that this

ID doesn't conflict with any other node ID on the network.



Select the Baud Rate: The only available baud rate for the DH+ network on a KT card is 57.6K.



Select the Memory Address: You must select the exact memory address that you set up on your card while

performing the hardware configurations.



Select the Interrupt: If you are using Interrupts, you must select a unique Interrupt level from the drop down

menu next to the "Interrupt" label. Make sure it matches what you have selected while performing the hardware