Specifications

24
www.kepware.com
Allen-Bradley DH+/DH-485 Device Driver Help
Note: If your computer still doesn't detect the SST-PCI device, you may have to try one or both of the following:
1. Completely uninstall any driver installed under the current slot.
2. Try a different PCI slot.
Step 2: Channel Properties Setup
1. In the server application, right-click on the channel and select Properties.
2. Select the Interface Card tab from the Channel Properties window.
3. Under the Interface Card tab, complete the following:

Select the Board Type: Select "5136-SD-PCI" as the "Board Type" from the drop down menu next to the
"Board Type" label.

Select the Network type: This driver currently supports only DH+ networks for 5136-SD-PCI cards.

Select the station address: This is a unique node ID (1-77 octal for DH+) of your device. You must make sure
that this ID doesn't conflict with any other node ID on the network.

Select the Baud Rate: The available baud rates are 57.6K, 115K and 230K. Select the one that matches your
device configuration.