Specifications

20
www.kepware.com
Allen-Bradley DH+/DH-485 Device Driver Help
1. Expand SST and select any driver under it. Right-click and select uninstall. You must do this for all drivers that are
installed under SST.
2. Once the procedure is complete, restart your computer.
Before setting the channel properties, you have to have an additional driver installed for the SST PCI card.
Note: You will not need any other drivers or software from any other vendor. Any additional driver/software that may
be required will either be supplied or recommended and described in this help file. Also, if you are using Windows NT,
instructions described in Step 1 are not required and should not be performed. The driver should automatically take
care of the steps required for the NT installation.
Step 1: Additional Driver Installation
1. After you have installed the card, restart your PC. At start up, the Found New Hardware Wizard will pop up to
configure the new detected hardware.
(Note: The pictures below refer to KSE_PKTXD2000 and are taken from a different case. They are presented here as an
example. Names vary from case to case.)
2. Select Install from a list or specific location (Advanced). Click Next.