Specifications

10
www.kepware.com
Allen-Bradley DH+/DH-485 Device Driver Help
1. Expand SST and select any driver under it. Right-click and select uninstall. You must do this for all the drivers that
are installed under SST.
2. Once the procedure is complete, restart your computer.
Before setting the channel properties, you have to have an additional driver installed for the PKTX/PKTX-D card.
Note: If you are installing the driver on Windows NT, instructions described in Step 1 are not required and should
not be performed. The driver should automatically take care of the steps required for installation.
Step 1 : Additional Driver Installation
1. After you have installed the card, restart your PC. At start up, the Found New Hardware Wizard will pop up to
configure the new detected hardware.
(Note: The pictures below refer to KSE_PKTXD2000. This name can vary from computer to computer. When installing
the device for the first time, some computers might say Network Controller. In this case, it is referring the device as
KSE_PKTXD2000.)
2. Select Install from a list or specific location (Advanced). Click Next.