Setup guide

Chapter 2 System Objects
Object Reference Manual 3-88 www.Automationdirect.com
You can add a secondary IP address to the CTI TCP/IP parameter.
Lookout now toggles between the primary and secondary IP address after
a COM failure (assuming a secondary address exists). Enter the secondary
ID after the first, preceded by a space or a comma. For example:
207.68.156.61, 1.2.3.4
Tiway Data Members
Table 3-17. Tiway Data Members
Data Members Type Read Write Description
AERR1 – AERR32000 numeric yes yes (Analog Alarm) Error
AHA1 – AHA32000 numeric yes yes (Analog Alarm) High alarm limit
AHHA1 – AHHA32000 numeric yes yes (Analog Alarm) High high alarm
limit
ALA1 – ALA32000 numeric yes yes (Analog Alarm) Low alarm limit
ALLA1 – ALLA32000 numeric yes yes (Analog Alarm) Low low alarm limit
AODA1 – AODA32000 numeric yes yes (Analog Alarm) Orange deviation
limit
APVH1 – APVH32000 numeric yes yes (Analog Alarm) Process variable high
limit
APVL1 – APVL32000 numeric yes yes (Analog Alarm) Process variable low
limit
ARCA1 – ARCA32000 numeric yes yes (Analog Alarm) Rate of change limit
ASP1 – ASP32000 numeric yes yes (Analog Alarm) Setpoint
ASPH1 – ASPH128 numeric yes yes (Analog Alarm) Setpoint high limit
ASPL1 – ASPL128 numeric yes yes (Analog Alarm) Setpoint low limit
ATS1 – ATS32000 numeric yes yes (Analog Alarm) Sample rate
AVF1 – AVF128 numeric yes yes (Analog Alarm) Alarm flags
C1 – C32000 logical yes yes Control Registers
CommFail logical yes no Driver-generated signal that is ON if
Lookout cannot communicate with
the device for whatever reason