Setup guide

Chapter 2 System Objects
Object Reference Manual 3-48 www.Automationdirect.com
GE_Series90
GE_Series90 is a protocol driver class Lookout
Direct
uses to communicate
with GE Series 90-30 and GE Series 90-70 programmable logic controllers
(PLCs) using SNPX, a Series Ninety Protocol.
PLC Address is a slave address and refers to the PLC address setting as
configured on the device. The address can be up to eight ASCII characters.
Model chooses either 90-30 or 90-70.
Interface selects the protocol. You can choose between SNPX and
Ethernet.
Serial port specifies which port the object uses for communication to
the external device. This does not specify the communication type.
Communication type is determined by the Options»Serial Ports…
command.
Data rate, Parity, Data bits, and Stop bits reference the settings on the
hardware device.
Phone number specifies the number to be dialed if the serial port setting
is configured for dial-up. This number only applies to the individual
protocol object.