Setup guide

Chapter 3 Driver and Protocol Objects
©
Automationdirect.com 3-37 Object Reference Manual
DirectLogic
The DirectLogic protocol driver object class is used to communicate to
PLC Direct by Koyo 105, 205, 305, and 405 PLCs. This driver object
supports additional Koyo private labeled PLCs under GE Series One, Texas
Instruments Series 305, 405 and Siemens Simatic TI305, TI405 names.
Please see the Protocol Reference Chart within the LookoutDirect Learning
Guide to verify the part numbers of these additional Koyo PLCs.
LookoutDirect supports both point-to-point, multidrop and Ethernet
configurations. You can connect LookoutDirect to a fixed PLC
Programming port, a networking DirectNET/CCM port, PLC DCM (data
communications module), or to an Ethernet (ECOM) communications
module.