Setup guide

Chapter 3 Driver and Protocol Objects
Object Reference Manual 3-20 www.Automationdirect.com
KT card timed out while loading protocol code
KT card failed with status code xx while loading protocol
Lookout
Direct
was not able to transfer a loader file to the card and
subsequently download the card protocol firmware. Try to restart the
interface card by calling up the AB object definition dialog box and
selecting OK. If that does not work try rebooting the computer.
KT card is no longer responding
The Lookout
Direct
AB object did not receive the interface card heartbeat
within the last second. Normally, the card generates a heartbeat any time it
receives the DH+ network token. If the alarm does not deactivate after
30 seconds, try to restart the card by calling up the AB object definition
dialog box and selecting OK. If that does not work try restarting
LookoutDirect or rebooting the computer.
KT card memory address conflicts with card n
Lookout
Direct
found another interface card with the same memory
address. Be sure that the memory address on each interface card is different
and that the corresponding Memory address in the Lookout
Direct
object
matches the card address.
KT card not present in this computer
The Card exists in this computer check box is deselected (this is the
default setting). Select Object»Modify to retrieve the PLC definition
parameters dialog box and select the Card exists in this computer check
box and OK to initialize the card.
KT card RAM test timed out
KT card RAM test failed with status code xx
The interface card failed a memory test when it was first powered on. The
memory test writes a pattern to on-board RAM and reads its content to
verify the card memory is working. Confirm that the memory address
specified in the Object»Modify dialog box is correct. You may need to
restart, reseat, or replace the card.
KT card signature test failed
The AB object does not recognize the card. Make sure that the interface
card is actually installed in the PC and that you indicated the correct
memory address in Lookout
Direct
. You may need to reseat the card, or the
card may require repair. Also ensure that you did not identify more
Card Numbers than actual physical cards.