Specifications

Allen-Bradley DH+ Driver Help

3. Configure the following properties:

l Board Type: Select "KT" from the drop-down menu.

l Network Type: Select the type of network that is being used. This driver currently only supports the

DH+ Network.

l Station Address: Select the device's unique Node ID, which ranges from 0-77 octal. Make sure that this

ID does not conflict with any other Node ID on the network.

l Baud Rate: The only available baud rate for the DH+ network on a KT card is 57.6K.

l Memory Address: Select the memory address that was specified on the card during hardware

configuration.

l Interrupt: If using interrupts, select a unique interrupt level from the drop-down menu. Make sure that

it matches what was specified during hardware configuration. For no interrupts, select "None."