Specifications

ManualsBrandsAllen-Bradley ManualsComputer equipment1784-KT/B

Allen-Bradley DH+ Driver Help

3. The parameters selected for Channel Setup may be incorrect.

4. The card is corrupted.

Solution:

1. Verify all the pins are hooked into the slot comfortably.

2. Verify that the Instance ID is not used by any other PKTX card.

3. Modify the Channel Properties with appropriate values.

4. Replace the card.

Failed to write to Dual port memory for device: <device name>

Error Type:

Fatal

Possible Cause:

1. A network failure occurred.

2. Memory Conflict.

3. The parameters selected for the Channel Setup may be incorrect.

4. The parameters selected for the Channel Setup may be incorrect.

5. The card is corrupted.

Solution:

1. Check for any broken links between the card and the host. Make sure that the card is inserted properly on the

appropriate slot and then restart the driver.

2. Assign a different memory base address.

3. Change the Channel Setup parameters with appropriate values.

4. Modify the Channel Properties with appropriate values.

5. Replace the card.

Failed to clear dual port memory while performing functionality test

Error Type:

Fatal

Possible Cause:

This error may occur due to a conflict between this OPC server and any other OPC servers supporting Allen-

Bradley Data Highway drivers.

Possible Solutions:

Make sure that all other OPC servers (such as RSLinx) are completely uninstalled, and then restart the PC.

Failed to start Board <board name>. Possible Resource Conflict

Error Type:

Fatal

Possible Cause:

1. Memory Conflict.

2. Temporary network problem.

3. Bad memory address selected.

4. The parameters selected for Channel Setup may be incorrect.

5. The card is corrupted.

Solution:

1. Some other device may be using the same memory address. Configure device with different memory address.

2. Restart the driver.

3. Memory address selected is not within the range. Try a different memory address.

4. Modify the Channel Properties with appropriate values.

5. Replace the card.

M16 Diagnostic 8-bit mode failure

Error Type:

Fatal

Possible Cause:

This occurs when the jumper settings on the KTXD card are in 8 bit mode.