Specifications

Allen-Bradley DH+ Driver Help
Error Descriptions
The following error/warning messages may be generated. Click on the link for a description of the message.
Address Validation
Missing address
Device address '<address>' contains a syntax error
Address '<address>' is out of range for the specified device or register
Device address '<address>' is not supported by model '<model name>'
Data Type '<type>' is not valid for device address '<address>'
Device address '<address>' is read only
Array size is out of range for address '<address>'
Array support is not available for the specified address: '<address>'
Configuration Error Messages
File Corruption
Interrupt not configured
Device Status Messages
Device '<device name>' is not responding
Unable to write to '<address>' on device '<device name>'
Failed to Connect to device '<device name>'
Device Specific Messages
Unable to read data starting at address '<address>' on device '<device name>'. Frame received
contains errors
Unable to read data starting at address '<address>' on device '<device name>'. [STS=<value>, EXT
STS=<value>]. Tag deactivated
Unable to write to address '<address>' on device '<device name>'. Frame received contains errors
Unable to write to address '<address>' on device '<device name>'. [STS=<value>, EXT
STS=<value>]
Allen-Bradley Card Specific Error Messages
Failed to locate PKTX Channel 'Channel ID' of card 'PKTX Card ID'
Failed to write to Dual Port memory for device: '<device name>'
Failed to clear dual port memory while performing functionality test
Failed to start Board <board name>. Possible Resource Conflict
M16 Diagnostic 8-bit mode failure
Failed RAM, CTC or SIO Test
Failed to enable card for device '<device name>'
Failed to perform M16 Key write for device '<device name>'
Failed to complete diagnosis while performing M16 Diagnosis for device '<device name>'
Failed to complete loading protocol file while performing M16 diagnosis for device '<device name>'
Failed to load binary resource <Resource ID> for device '<device name>'
Failed to allocate device for board '<channel>'
Error performing diagnostics test on channel '<channel name>'
SST Specific Error Messages
Duplicate Station ID detected by device '<device name>'
Invalid Station ID detected by device '<device name>'
Error writing to SST ports for device '<device name>'
Failed to take the SST card offline for device '<device name>'
Bad port/memory detected on SST card while loading module on device '<device name>'
Protocol is not reflected onto memory after being loaded on device '<device name>'
SST card execution error occurred on device '<device name>'
Failed to allocate device for board '<channel>'
Address Validation
The following error/warning messages may be generated. Click on the link for a description of the message.
Address Validation
www. kepware.com
57