Specifications

ManualsBrandsAllen-Bradley ManualsComputer equipment1784-KT/B

Allen-Bradley DH+ Driver Help

selected, users should place one of the jumpers horizontally across pin 3 under channel number 1. If not using

interrupts, the jumper should be placed vertically, thus connecting pins of two different interrupt levels (such as

3 and 5).

Configuring the 1784-KT (ISA Bus) Communication Interface Card for DH+

Important: Before handling the card, users must ground themselves by touching a grounded object (such as

the chassis of the computer).

Requirements for the 1784-KT (ISA Bus) card are as follows:

l The 1784-KT card's DIP switch configuration must match the driver's KT communications address

settings.

l The selected address must not conflict with any other address used by the computer.

l If planning to use multiple 1784-KT cards, each one must be assigned a unique address.

1784-KT Card DIP Switch Configuration for DH+

MEMORY ADDRESS IN HEX SW1 SW2 SW3 SW4 SW5 SW6

Use these addresses only if an EGA

or VGA display adapter is not

installed.

A0000

A4000

A8000

AC000

OPEN

CLOSED

OPEN

CLOSED

OPEN

CLOSED

OPEN

CLOSED

OPEN

CLOSED

Use these addresses only if an MDA

display adapter is not installed.

B0000

B4000

B8000

OPEN

CLOSED

OPEN

CLOSED

OPEN

CLOSED

Use these addresses only if the

Dxxxx addresses do not work (since

one of the Cxxxx addresses may be

used by the AT BIOS).

C0000

C4000

C8000

CC000

OPEN

CLOSED

OPEN

CLOSED

OPEN

CLOSED

OPEN

CLOSED

These addresses will yield the best

results. The default address is

shown in bold.

D0000

D4000

D8000

OPEN

CLOSED

OPEN

CLOSED

OPEN

CLOSED

DIP Switches on the 1784-KT Card Shown for Default D4000

1. Configure the 1784-KT card DIP switches by pressing each switch in at the top or in at the bottom.

Descriptions of the settings are as follows:

l Open: Pressed in at the top.

l Closed:Pressed in at the bottom .