Specifications

Allen-Bradley DH+ Driver Help

1. To start, expand SST. Select any driver beneath it and then right-click and select Uninstall. This must be

done for all drivers that are installed under SST.

2. Once the procedure is complete, restart the computer. Before the Channel Properties are set, users must have

an additional driver installed for the SST PCI card.

Note: No other drivers or software will be needed from any other vendor. Any additional driver/software that may

be required will either be supplied or recommended. Also, when using Windows NT, the instructions described

in Step 1 are not required and should not be performed. The driver should automatically take care of the steps

required for the NT installation.

Step 1: Installing Additional Drivers

1. After the card has been installed, restart the PC. At start up, the Found New Hardware Wizard will pop up to

configure the newly detected hardware.

Note: The images below refer to "KSE_PKTXD2000" and are taken from a different case. They are presented here

as an example. Names vary from case to case.

2. Select Install from a list or specific location (Advanced) and then click Next.