Specifications

Allen-Bradley DH+ Driver Help

3. Under the Interface Card tab, make the following changes:

l Board Type: Select "PCMK/B" from the drop-down menul.

l Network type: This driver currently supports DH+ and DH-485 networks for PCMK/B cards.

l Station Address: This is the device's unique Node ID: 0-77 octal for DH+ and 0-31 decimal for DH-485.

Users must make sure that this ID does not conflict with any other Node ID on the network.

l Baud Rate: The available baud rates for the DH+ network are 57.6K, 115K and 230K. The baud rates

115K and 230K under the DH+ network may not be supported by the card or device. For more

information, refer to the card and device's vendor specifications. The available baud rates for the DH-485

network are 300, 600, 1.2K, 2.4K, 4.8K, 9.6K, and 19.2K. Select the one that matches the device

configuration.

l PCI Card Instance: This number depends on the number of PCMK card instances on the computer. If

the card is the first PCMK being installed, the PCI Card Instance ID should be 0. Up to 4 card instances are

allowed at a time. Therefore, the maximum PCI Card Instance that can be selected is 3.

4. Click OK.

Channel Setup for the AB-1784-U2DHP USB Card

The 1784-U2DHP USB adapter converts DF1 to DH+. For more information on configuration, refer to the Allen-

Bradley DF1 Driver help file.

Channel Setup for 5136-SD-ISA Card

Note: Users will not need any additional drivers or additional software from any other vendor. Any additional

drivers/software that may be required will either be supplied or recommended.

Step 1: Configuring the SST ISA Card

For more information on configuring the I/O port and jumper settings on the SST ISA card, refer to Hardware

Configuration of the 5136-SD-ISA (SST) Card.

Step 2: Setting Up the Channel Properties

1. In the server application, right-click on the channel and then select Properties.