Specifications

Allen-Bradley DH+ Driver Help

1. To start, expand SST. Select any driver beneath it, and then right-click and select Uninstall. This must be

done for all the drivers that are installed under SST.

2. Once the procedure is complete, restart the computer. Before setting the Channel Properties, users must

install an additional driver for the PKTX/PKTX-D card.

Note: If the driver is being installed on Windows NT, the instructions described in Step 1 are not required and

should not be performed. The driver should automatically take care of the steps required for installation.

Step 1: Installing Additional Drivers

1. After the card has been installed, restart the PC. At start up, the Found New Hardware Wizard will pop up to

configure the newly detected hardware.

Note: The images below refer to "KSE_PKTXD2000." This name can vary from computer to computer. When

installing the device for the first time, some computers might say "Network Controller." In this case, it is referring

to the device as "KSE_PKTXD2000."

2. Select Install from a list or specific location (Advanced) and then click Next.