Specifications

Allen-Bradley DH+ Driver Help

3. Configure the following properties:

l Board Type: Select "KTX(D)" from the drop-down menu.

Note: In this example, KTX (D) has been chosen for both the KTX and KTX-D cards.

l Network Type: Select the type of network that is being used. This driver currently supports DH+ and

DH-485 networks.

l Station Address: This is the device's unique Node ID: 0-77 octal for DH+ and 0-31 decimal for DH-485.

users must make sure that this ID does not conflict with any other Node ID on the network.

l Baud Rate: The available baud rates for the DH+ network are 57.6K, 115K and 230K. Under the DH+

network, the baud rates 115K and 230K may not be supported by the card or device. For more

information, check the card and device vendor's specifications. The available baud rates for the DH-485

network are 300, 600, 1.2K, 2.4K, 4.8K, 9.6K, 19.2K. The selected baud rate should match the device

configuration.

l Memory Address: Sselect the exact memory address that was specified on the card during hardware

configuration. For more information, refer to Hardware Configuration of Memory and Interrupt on

1784 KTXD Card.

l Interrupt: If using Interrupts, select a unique interrupt level from the drop-down menu. Make sure it

matches what was specified during hardware configuration. If not using interrupts, select "None."