Specifications

Page 3-2
1770-805
3.3 KEYBOARD CONNECTOR COVER
INSTALLATION
If the Industrial Terminal System is used as a
monitor (without a keyboard), the keyboard
connector cover MUST be installed. When
attaching the keyboard connector cover,
tighten the two mounting screws (Figure 3-3)
by hand; do not overtighten.
3.4SELECTING AC INPUT VOLTAGE RANGE
All Industrial Terminal CRT Monitors are
shipped configured for 120V AC, 60 Hz
operation.
The CRT Monitor can be configured for
220/240V AC operation by repositioning the
AC selector board, located on the back of the
Industrial Terminal CRT Monitor (Figure 3-4).
The board has four positions: 100, 120, 220
and 240. When either 100 or 120 is selected,
the voltage range is 98 to 132V AC. When 220
or 240 is selected, the voltage range is 196 to
250V AC.
When
the Industrial Terminal System is set up
for 220/240V AC operation, place the 230V
Mounting
Screws
,/./
...
\
Keyboard Connector Cover
FIGURE 3-3- Attaching Keyboard Connector
Cover
Wire
Loop
AC Selection
Board
Plastic
Slide Cover
Fuse
Fuse
Pull
Lever
Label Here
FIGURE 3-4- AC Voltage Selection and Fuse
Replacement
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com